Mushroom plug tire repair patch,Lead wire combination units-wrapped stem
Brand: | SUNSOUL |
Original produced | Ningbo,China |
Port: | Ningbo/Shanghai |
Delivery: | 3-4 Weeks |
Payment Terms: | T/T,L/C,D/P,PAYPAL,WESTERN UNION |
- Inquiry
Short Description:
Mushroom plug tire repair patch
Lead wire combination units-wrapped stem
※Plug repair unit require no special wire pulling tools.
Just insert the plug into the injury from the inside of the
tire and pull the repair unit through from the outside.
※Both the stem and the repair unit are gum coated to provide the most complete bond,
both through the injury and on the inner liner
※The plug repair patches are black with gray vulcanizing gum and will vulcanize
chemically or in a heat curing system.
Lead wire combination units-wrapped stem
● Direction:
►REPAIR PROCEDURES FOR COMBINATION REPAIR UNITS
Before repairing, mark and remove puncturing object. With tyre inflated, apply soap solution
to damaged area to determine.if air loss is from one or more punctures. Remove tyre from wheel carefully
to avoid further damage and place on spreader.
►PROBING
Probe puncture to determine size and direction of injury,making sure to remove all foreign materials.
DO NOT repair it when injury is beyond puncture repair limits.
►INTERNAL EXAMINATION
Spread the beads and mark the damaged area with a crayon.Carefully inspect tyre to ensure that
all damage is within,repairable limits. If limits are exceeded, DO NOT repair the tyre.
►REPAIR UNIT SELECTION
If injury is 1/4”(6mm) or smaller in diamater and angle does not exceed 25Y,
a combination repair unit is the easiest method of repair.Reinforced Combination Units are for tread
area only Universal and Lead-Wire Combination Units may be used in any repairable area.
►CLEANING
Using buffing solution and an inner scraper,clean thoroughly an area slightly larger than the patch
head of the repair unit. This serves to remove dirt and mold lubricants for better adhesion.
►BUFFING
Using a buffing wheel, buff repair area to texture taking care not to gouge the inner liner.
Using appropriate reamer of cutter(for lead-wire units),drill injury channel from inside and from outside,
removing damaged cables and debris. Vacuum away buffing dust.
►CEMENTING
Apply vulcanizing cement to the injury channel and prepared repair area.
Work cement into the rubber. DO NOT puddle or scrape pff. ALLOW CEMENT TO DRY THOROUGHLY.
►INSERTION
Remove backing from patch head(and stem fo Lead-Wire Units) DO NOT touch gum surface.
Push quill or lead wire into the injury from inside and pull through with pliers.
Pull until patch head is seated firmly against the inner liner.
►FINISH REPAIR
● Specification:
